J--LAKE26-0012-REPAIR CAT 44O BACKHOE

Statement of Work (SOW) / Performance Work Statement (PWS)

This document outlines the requirements for repair services for a Caterpillar 440F2 Backhoe owned by the Lake Mead National Recreation Area (LAKE).

• The contractor will perform repairs on a specific Caterpillar 440F2 Backhoe (Serial No.: ODC900457, VIN: CAT00440LDC900547).

• The contractor's shop must be located within 100 miles of the Lake Mead Maintenance complex (101 Katzenbach Drive, Boulder City, NV 89002).

• The contractor is responsible for all labor, tools, and parts needed for the repairs.

• Major repair tasks include:

  • Replacing leaking hydraulic hoses, clamps, seal-o-rings, and lines at the hydraulic tank.
  • Repairing, testing, and adjusting the bucket linkage positioning sensor.
  • Repairing hydraulic leaks on the left and right rear stabilizer cylinders.
  • Repairing hydraulic leaks on the rear boom cylinder.
  • Repairing hydraulic leaks on the stick cylinder.
  • Repairing hydraulic leaks on multipurpose bucket cylinders (Level 1 reconditioning, including seals and gaskets).
  • Replacing the product link system wiring harness and antenna.
  • Replacing the cabin roof panel, power outlet, and wiring harness on the front right-hand top corner and roll-over protection system.
  • Refilling all hydraulic fluids to recommended levels and performing a fluid analysis.
  • Testing all hydraulic lines for leaks after installation.

• The contractor must only complete work specified in this document unless authorized otherwise by the contracting officer.

• All tasks must be completed within 40 calendar days after award.

• The equipment will be transported to the contractor's shop by Lake Mead Staff and returned after acceptance by the COR.

• The contractor must contact the Contracting Officer's Representative (COR) to schedule an onsite inspection upon completion of repairs.

• If additional issues are discovered, the contractor must stop work and contact the contracting officer for guidance.

Solicitation / RFP / RFQ

This is a combined synopsis/solicitation for commercial items to procure equipment repair services for a National Park Service (NPS) CAT 440F2 Backhoe. The acquisition is in support of Lake Mead National Recreation Area. A written solicitation will not be issued; this announcement constitutes the only solicitation.

• Repair services for NPS CAT 440F2 Backhoe.

• Work must be performed by a CAT certified mechanic.

• Work to be performed in accordance with Attachment 1 - Statement of Work.

• The period of performance is from 05/08/2026 to 06/17/2026.

• The contract will be a firm-fixed-price contract.

• Delivery is required 40 days after receipt of order.

• Quotations are due by 04/15/2026 at 1700 PD.

• Offers must be submitted via email to caleb_overbaugh@ios.doi.gov.

• Evaluation will be based on a comparative evaluation of offerors, considering Price, Technical (Pass/Fail), and Warranty.

• Technical evaluation requires proof of CAT certification and confirmation that the contractor has a shop within a 100-mile radius of 101 Katzenbach Dr, Boulder City, NV 89005.

• Any exceptions to clauses or provisions may not be considered for award.

• This solicitation does not have a set-aside requirement.

• North American Industry Classification System (NAICS) code is 811310.

• Offerors must be registered in the System for Award Management (SAM).

• Attachment 1: Statement of Work (3 pages).

• Attachment 2: SCA Wage Determination (10 pages).

• The Government will be dropping off and picking up the equipment.

Form / Attachment / Pricing Sheet

This document is a Wage Determination (No. 2015-5593, Revision No. 30) issued by the U.S. Department of Labor, Employment Standards Administration, Wage and Hour Division, under the Service Contract Act. It establishes the minimum wage rates and fringe benefits required for various occupations when performing contract work in Nevada County, Clark, Nevada.

• Lists numerous occupational codes and titles.
• Specifies the minimum hourly wage rate for each occupation.
• Indicates that "Fringe Benefits Required Follow the Occupational Listing."
• Includes notes on Executive Orders 13706 (Paid Sick Leave) and 13658 (minimum wage adjustments).
• Details requirements for paid sick leave, vacation, and holidays.
• Provides information on hazardous pay differentials (8% for high hazard, 4% for low hazard).
• Outlines uniform allowance requirements.
• Explains the conformance process for unlisted classifications using Standard Form 1444 (SF-1444).

This document is critical for bidders to understand the labor costs associated with performing the contract. It dictates the minimum wages and benefits that must be paid to employees working on the contract, directly impacting proposal pricing and overall cost. Bidders must ensure their proposed wages and benefits meet or exceed these requirements.