SANDING BOOTH SYSTEM
Overview
Buyer
Place of Performance
NAICS
PSC
Set Aside
Original Source
Timeline
Qualification Details
Fit reasons
- NAICS alignment with historical contract wins in similar service areas.
- Scope strongly matches core technical capabilities and delivery model.
Risks
- Past performance thresholds may require one additional teaming partner.
- Potential clarification needed on staffing minimums before bid/no-bid.
Next steps
Validate eligibility requirements, assign capture owner, and schedule partner outreach to confirm teaming strategy before submission planning.
Implemented Amendment to include Set Aside Code from N/A to Total Small Business Set-Aside. Purchase Description for a Sanding BoothScopeThe following document provides the requirements and specifications for the sanding booth.Applicable Documents1. Standards and Regulations:a. NFPA 33b. OSHA CFR-29.1910.1072. Additional DocumentsRequirements3. General RequirementsThis section provides the design specification requirements for the sanding booth.a. Two stage filtration to capture sanding booth dustb. Must accommodate a monorail fed down the middle of the working area4. Specific RequirementsThis section provides specific requirements for the sanding booth equipment requested.a. Inside working dimensionsi. 7 ft. W x 9 ft. 6 in. H x 36 in. D front and back booth section separated by a 5 in. overhead gap for the monorail fed item to be sanding1. Entrance and exit of booth with be notched out to make an overall opening of 25 in. W x 106 in. Tii. 7 ft. 4 in. W x 10 ft. 2 in. H x 12 ft. 2 in. D overall outside dimensions to include the 2-stage filtration and exhaust plenumb. Constructioni. 18g reinforced steel panels1. Pre-punched on 6 in. centers for nut/bolt construction2. Equipped with galvanized companion flanges for rust resistancec. Lightingi. Two 4,000 lumen light fixtures1. Sealed/gasketed2. High efficiency LEDd. Exhaust filtrationi. First stage1. Blanket style poly roll media with Filterloc management system with complete locking frame to hold media in place without gaps or leaksii. Second stage1. Pocket/bag filtersiii. On board manometer1. Displays air resistance across filter systeme. Exhaust fani. 36 in. diameter tube-axial duct fanii. Spark resistant fan bladesiii. Rated at 15,525 CFM at 1.25 in. static, 10 HPiv. Belt driven with motor pulley, fan-pulley, v-belts, motor base, lubricated sealed bearingsv. Thermal resetsf. Exhaust stacki. Fan connector ring to connect fan to boothii. Section of stack above fan equipped with inspection plateiii. 90 deg elbowiv. Section of stack for horizontal flowv. Exterior wall mount louvered damper assembly